Friday, July 10, 2020
Terminate Power Automate Run
In one of our recent requirements, we had Switch case in Power Automate and then actions to be done based on the variable populated in the Switch case.
If any of the case was not satisfied, we did not want to the actions after the Switch case to be performed.
In such scenarios, Power Automate's Terminate Action comes in handy.
Add Action terminate.
It gives option to select status( this status will be shown in the run history of Flow).
For status as Failed- power automate allows to add Code and Message for failure as well.
We can also configure run of terminate based on status of previous action.
Introduction : We had a requirement where based on switch case condition, we had to populate different word templates. Power automate A...
Introduction: In this post I plan to walk you through some concepts and functional aspects of CRM module of Dynamics 365. We will loo...
Introduction: This blog give the steps to access Recycle Bin of SharePoint using Microsoft Flows. Steps: In Actions, select &qu...
Introduction: In this post, we will read about solutions,Components and Import-Export of solutions in Dynamics CRM. Also we will see...